Watchguard XCS

When you configure your WatchGuard XCS to send log data to USM Appliance, you can use the WatchGuard XCS plugin to translate raw log data into normalized events for analysis. The table below provides some basic information for the plugin.

Plugin Information
Device Details
Vendor WatchGuard
Device Type Mail Server
Connection Type Syslog
Data Source Name Watchguard-xcs-mg
Data Source ID 1900

Integrating WatchGuard XCS

Before you configure the WatchGuard XCS integration, you must have the IP Address of the USM Appliance Sensor.

To configure WatchGuard XCS to send log messages to USM Appliance

  1. From the WatchGuard XCS web UI, select Configuration > Network > Interfaces.
  2. In the Syslog Server field, enter the USM Appliance IP address.
  3. Click Apply.

Plugin Enablement

For plugin enablement information, see Enable Plugins.

Additional Resources and Troubleshooting

For troubleshooting, refer to the vendor documentation: