Add a New Sensor

Role Availability Read-Only Analyst Manager

After your USM Anywhere service is provisioned and running, you can add and deploy new sensors as needed. For these sensors, instead of receiving an authentication code from AT&T Cybersecurity, you must generate the license key for any new sensor you intend to add from within the USM Anywhere web UI. The rest of the sensor deployment process is the same as the first one.

Note: The number of sensors that you can add to your environment depends on your USM Anywhere licensing. You can go to Settings > My Subscription to view the number of licensed sensors.

To add a new USM Anywhere Sensor

  1. Deploy your sensor.

    Follow the instructions based on your sensor type:

  2. Obtain an authentication code for the new sensor.
    1. In USM Anywhere, go to Data Sources > Sensors.
    2. Click New Sensor.

      The dialog box displays an authentication code for the new sensor. This code starts with an "S".

      Copy the authentication code for a new USM Anywhere Sensor

    3. Click the icon to copy the code to your clipboard.
  3. Register your sensor.

    Click tor enter the URL of your sensor to get to the setup page. It prompts you to provide the following information:

    1. Enter a name and description for the sensor.
    2. In the field with the key () icon, paste the sensor authentication code you copied.
    3. In the field with the computer () icon, copy and paste the URL of your existing instance.

      For example, if the subdomain with which you registered with AT&T Cybersecurity was "mycompany," the URL would be for USM Anywhere.

      Enter the sensor authentication code and your USM Anywhere URL/domain

    4. Click Start Setup.

      A progress dialog box displays a status message.

      Connecting USM Anywhere Sensor

      When the connection is complete, a confirmation message appears.

      The system displays a success message and link to your USM Anywhere instance

    5. Click the link to open the USM Anywhere web UI.

      Upon login, this displays the USM Anywhere Sensor Configuration page with the connected sensor listed in the page.

  4. Configure your sensor.

    Follow the instructions based on your sensor type:

    Note: If you do not want to complete the sensor setup immediately, you can click Start Using USM Anywhere at the bottom of the page. However, AT&T Cybersecurity strongly recommends that you do so now, because you must complete the sensor setup before you can use it.

Related Video Content

To view other related training videos, click here.